PREPARE SURFACE

Pressure wash, sweep, dust or wire-brush to remove dirt and debris. If efflorescence (white residue) is present, wash surface with required amount of cleaning solution, then rinse with water.

APPLICATION

Use any agreeable application method: brush, roller or spray. Apply one coat liberally so as to flood the surface to a maximum absorption as indicated by a run-down of 6 to 12 inches, but not to allow to puddle on horizontal surfaces. Application notes:

• It is important to apply to dry surfaces in warm temperatures and/or direct sunlight.
• If thorough saturation is obtained, one coat will give excellent water repellency.
• No thinning is necessary.
• Do not apply if rain is likely to occur soon after application.

• Stucco
• Concrete slabs
• Marble
• Stone masonry
• Walkways
• Brick
• Tile roofs

• Tile floors,
• showers,
• kitchen counters
• Concrete porches
  and steps
• Man-made
  masonry veneering
• Tile grout